This system allows eight (8) user defined parameter sets (programs) to be set up to control the torque, RPM profile, direction and time for any PLUTO screwdriver: The system also displays a torque value after every tightening that is calibrated back to an external transducer at setup. The system is controlled through a LCD display on the front of the unit. Changes to the parameters are performed by scrolling through the settings using four buttons, no PC is required.
The electronic control circuit cuts the power supply to the motor calculating the correct torque in response to 3 parameters: voltage, frequency and current, according to the user selectable parameters below.
-
Torque Range: 2.6 - 442 in.lbs (Tool Dependent)
-
RPM Range: 40 - 1200 (Tool Dependent)
-
Screw Size: M2 to M8
-
Voltage: 110V
-
Dimensions: 196 x 170 x h110 mm
-
Weight: 9 lbs
-
Repeatability: Joint/profile dependent
-
Accuracy: Joint/profile dependent
-
Time Control: Standard
-
RPM Control: Standard
-
Screw Counting: Standard
-
Profile Sequencing: Standard
-
Parameter Sets: Eight (8)
-
Torque Settings: Eight (8)
-
Torque Control: Standard
