Ampertangid Fluke I300Flex, 3000A AC (Rogowski printsiibil)
Võta ühendust
Tellimused ja päringud
info@yeint.eeTehniline informatsioon ja projektid
Keio Kalm keio.kalm@yeint.eeKaal | 500 g |
---|---|
Mõõtühik | tk |
Tootekood | 412179 |
Osa number | FLUKE I3000FLEX-36 |
Kaubamärk | FLUKE |
Estonia
Tellimuse järgi
Fluke i3000s Flex-36 vahelduvvooluklamber, 915 mm (36 tolli)
i3000s Flex on vahelduvvooluklamber, mis kasutab Rogowski põhimõtet. Seda saab kasutada kuni 3000 A voolu mõõtmiseks, kui seda kasutatakse koos ostsilloskoopide, salvestajate või andmelogijatega. Paindlik ja kerge mõõtepea võimaldab kiiret ja lihtsat paigaldamist raskesti ligipääsetavates kohtades.
Fluke i3000s Flex-36 AC Current Clamp, 915 mm (36 in.)
Electrical Specification
Current ranges 30 A
300 A
3000 A
AC rms
Output sensitivity (AC-coupled) 100 mV
10 mV
1mV per A
Load impedance 100 kΩ minimum
Accuracy at +25°C: ±1% of range (45 Hz to 65 Hz)
Linearity 10% to 100% of range: ±0.2% of reading
Noise 8 mV AC rms (30 A)
2 mV AC rms (300 A, 3000 A)
Frequency range 10 Hz to 50 kHz (-3 dB)
Phase error < ±1° (45 Hz to 65 Hz)
±10° (at 20 kHz)
Position sensitivity (with cable > 25 mm from the coupling)
Position sensitivity: From 1% up to 3% of range with cable, depending on distance from the center (see figure left). Measurements closer than 25 mm from the coupling are typically greater than 3% of range.
External wire influence: 1% (-40 db) of external current >200 mm from head.
External field with cable > 200 mm from the head: ±1% of range
Power supply 2 x AA/MN 1500/LR6 Alkaline, 400 hours, low battery indicator
Temperature coefficient ±0.08% of reading per °C
Working voltage see Safety standards section: 600 V AC rms or DC
General Specifications
Head circumference 915 mm (36 in.)
Head cable diameter 14.3 mm (0.56 in)
Head bend radius 38.1 mm (1.5 in)
Cable length (head to electronics) 2 m (6.56 ft)
Output connection 0.5 m cable terminated with safety BNC connector. Supplied with 4mm safety plug adapter
Operating temperature range -20°C to +90°C (-4°F to 190°F) (head)
-20°C to +85°C (-4°F to 185°F) (electronics)
Storage temperature range -40°C to +105°C (-40°F to 221°F) (head)
-20°C to +85°C (-4°F to 185°F) (electronics)
Operating humidity 15% to 85% (non-condensing)
Weight 180 g (0.396 lb) (head)
190 g (0.419 lb) (electronics)
Safety standards BS EN 61010-1: 2001
BS EN 61010-2-032: 2002
BS EN 61010-031: 2002
600 Vrms, Category III, Pollution Degree 2
Use of the probe on uninsulated conductors is limited to 600 V AC rms or DC and frequencies below 1 kHz
EMC standards EN 61326: 1998 +A1, A2, and A3
Head cable length (double insulated) 610 mm or 914 mm, depending on model
Fluke i3000s Flex-36 vahelduvvooluklamber, 915 mm (36 tolli)
i3000s Flex on vahelduvvooluklamber, mis kasutab Rogowski põhimõtet. Seda saab kasutada kuni 3000 A voolu mõõtmiseks, kui seda kasutatakse koos ostsilloskoopide, salvestajate või andmelogijatega. Paindlik ja kerge mõõtepea võimaldab kiiret ja lihtsat paigaldamist raskesti ligipääsetavates kohtades.
Fluke i3000s Flex-36 AC Current Clamp, 915 mm (36 in.)
Electrical Specification
Current ranges 30 A
300 A
3000 A
AC rms
Output sensitivity (AC-coupled) 100 mV
10 mV
1mV per A
Load impedance 100 kΩ minimum
Accuracy at +25°C: ±1% of range (45 Hz to 65 Hz)
Linearity 10% to 100% of range: ±0.2% of reading
Noise 8 mV AC rms (30 A)
2 mV AC rms (300 A, 3000 A)
Frequency range 10 Hz to 50 kHz (-3 dB)
Phase error < ±1° (45 Hz to 65 Hz)
±10° (at 20 kHz)
Position sensitivity (with cable > 25 mm from the coupling)
Position sensitivity: From 1% up to 3% of range with cable, depending on distance from the center (see figure left). Measurements closer than 25 mm from the coupling are typically greater than 3% of range.
External wire influence: 1% (-40 db) of external current >200 mm from head.
External field with cable > 200 mm from the head: ±1% of range
Power supply 2 x AA/MN 1500/LR6 Alkaline, 400 hours, low battery indicator
Temperature coefficient ±0.08% of reading per °C
Working voltage see Safety standards section: 600 V AC rms or DC
General Specifications
Head circumference 915 mm (36 in.)
Head cable diameter 14.3 mm (0.56 in)
Head bend radius 38.1 mm (1.5 in)
Cable length (head to electronics) 2 m (6.56 ft)
Output connection 0.5 m cable terminated with safety BNC connector. Supplied with 4mm safety plug adapter
Operating temperature range -20°C to +90°C (-4°F to 190°F) (head)
-20°C to +85°C (-4°F to 185°F) (electronics)
Storage temperature range -40°C to +105°C (-40°F to 221°F) (head)
-20°C to +85°C (-4°F to 185°F) (electronics)
Operating humidity 15% to 85% (non-condensing)
Weight 180 g (0.396 lb) (head)
190 g (0.419 lb) (electronics)
Safety standards BS EN 61010-1: 2001
BS EN 61010-2-032: 2002
BS EN 61010-031: 2002
600 Vrms, Category III, Pollution Degree 2
Use of the probe on uninsulated conductors is limited to 600 V AC rms or DC and frequencies below 1 kHz
EMC standards EN 61326: 1998 +A1, A2, and A3
Head cable length (double insulated) 610 mm or 914 mm, depending on model