BSS138 - 4 kanaliga kahesuunaline nivookonverter
Tootekood: ADA757
Tootja: Adafruit Industries
Ühik: tk
Müügipakend: 1
Saadavus: Tellimisel
Tarneaeg 10-15
tööpäeva
Mahub pakiautomaati: Jah
Hind ilma km: 4.33€
Lisa ostukorvi
Kogus:

Because the Arduino (and Basic Stamp) are 5V devices, and most modern sensors, displays, flash cards and modes are 3.3V-only, many makers find that they need to perform level shifting/conversion to protect the 3.3V device from 5V.

We do have some other handy level shifters in the shop, from the DIP 74LVC245 to the fancy bi-directional TXB0108. However, neither of these are happy to work with I2C, which uses a funky pull-up system to transfer data back and forth. This level shifter board combines the ease-of-use of the bi-directional TXB0108 with an I2C-compatible FET design following NXP's app note.

This breakout has 4 BSS138 FETs with 10K pullups. It works down to 1.8V on the low side, and up to 10V on the high side. The 10K's do make the interface a little more sluggish than using a TXB0108 or 74LVC245 so we suggest checking those out if you need high-speed transfer.

While we designed it for use with I2C, this works as well for  TTL Serial,  slow <2MHz SPI, and any other digital interface both uni-directional and bidirectional. Comes with a fully assembled, and tested PCB with 4 full bidirectional converter lines as well as 2 pieces of 6-pin header you can solder on to plug into a breadboard or perfboard.

 

The newer NXP app note explaining how it works (the older Philips version of the app note is also worth a read)

Kontaktid
Abi ja Info
Meie brändid
Uudiskiri
Kampaaniatooted
Uued tooted
Leiunurk
Pakikapid

Weller

YE õpinurk