Paindeandur 112.5mm
Tootekood: ADA182
Tootja: Adafruit Industries
Ühik: tk
Müügipakend: 1
Saadavus: Tellimisel
Tarneaeg 10-15
tööpäeva
Mahub pakiautomaati: Jah
Hind ilma km: 14.19€
Lisa ostukorvi
Kogus:

This sensor can detect flexing or bending in one direction. They were popularized by being used in the Nintendo PowerGlove as a gaming interface.

These sensors are easy to use, they are basically resistors that change value based on how much they're flexed. If they're unflexed, the resistance is about ~10KΩ. When flexed all the way the resistance rises to ~20KΩ. They're pretty similar to FSRs so following this tutorial will get you started. You can use an analog input on a microcontroller (with a pullup resistor) or a digital input with the use of a 0.1uF capacitor for RC timing.

The bottom part of the sensor (where the pins are crimped on) is very delicate so make sure to have strain relief - such as clamping or gluing that part so as not to rip out the contacts!

  • Length: 112.5mm
  • Width: 6.38mm
  • Thickness: 0.5mm
  • Weight: 0.5g

Downloads:

Datasheet from SpectraSymbol

Kontaktid
Abi ja Info
Meie brändid
Uudiskiri
Kampaaniatooted
Uued tooted
Leiunurk
Pakikapid

Weller

YE õpinurk